Epoxy Based Paint
For concrete, timber or steel floors
Spray, roller or brush application.
Resists water, oils, acids and alkalis.
Non-spark finish
Non-Slip Paint
Product Description:
An anti-slip floor paint based on an epoxy ester formulation that dries to a tough durable finish. Has good resistance to water, oils, mild acids and alkalis. Available in 3 colours
Recommended Use
Suitable for use on timber, steel and concrete floors (in entrance halls, garages, canteens, workshops, etc). Possesses good resistance to water, oils, acids and alkalis.
Ideal for use on concrete, timber and steel floors. Anti-slip properties are produced by the use of organic powder which eliminates the risk of sparking from metal wheels, providing enhanced safety in certain hazardous environments.
Anti-slip properties produced by the use of organic powder gives enhanced safety to slippery areas.
Recommended Application:
Conventional spray, Roller or Brush
Pack Size: 5L tin.
Specification:
Finish: Non-slip sheen in Red, Green or Grey
Flash Point: 38ºC
Drying Time @ 20ºC:
Surface dry - 1½ hours.,
Hard dry - 5 hours.
Overcoat after 16 hours.
Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative
humidity exceeds 90%
Dry Film Thickness: 15 - 35 µ
Wet Film Thickness: 40 - 100 µ
Practical Covering Capacity:
Approximately 13 Sq M per litre @ 25 µ DFT
Slip Resistance:
Dry: 52 - Low slip potential
Wet: 44 - Low slip potential
(Results obtained using BS7976
Slider 96 Pendulum Test)
|
 |
 |
Other Information:
View Installation or Safety (COSHH) Datasheet on this page.
LEGAL:
As part of our policy of ongoing improvements, we reserve the right to
modify, alter or change product specifications without giving notice.
Product illustrations are representations only. All information contained
in this document is provided for guidance only, and as Intuchem Ltd has
no control over the installation methods of the products, or of the prevailing
site conditions, no warranties expressed or implied are intended to be
given as to the actual performance of the products mentioned or referred
to, and no liability whatsoever will be accepted for any loss, damage
or injury arising from the use of the information given of products mentioned
or referred to herein.
The above information to the best of our knowledge is true and accurate
and based upon current test data and is supplied for your guidance only.
Customers should satisfy themselves to the suitability of the product
in its intended use and no guarantee is given or implied since the conditions
of actual use are beyond our control. Intuchem Ltd disclaim any liability
for loss, damage or other expense arising from the use of information,
data or products mentioned or referred to and reserve the right to change
any details or specifications without notice.