Luminaire Hood Installation Guide

Installing a Luminaire Hood into a suspended grid system

The Intuchem Luminaire Hood provides 60 minutes protection by completely containing the fire and smoke within the hood, whilst at the same time allowing the heat from the light fitting to dissipate through the hood in normal use.

Fully tested to BS Standard 476 part 20 & 23 clause 5 Suitable for suspended and modular ceilings.

Sizes:

Square		Rectangular
300mm x 300mm x 50mm	0.7 kg	600mm x 300mm x 150mm	0.9 kg
600mm x 600mm x 50mm	1.0 kg	1200mm x 300mm x 150mm	1.0 kg
		1200mm x 600mm x 150mm	1.8 kg

Remove hood from packaging and unfold.

Place over the luminaire fitting and align cable entry in hood with cable.

All hoods have single or dual cable access, for dual cable access remove the sealing bolt as shown.

 

 

 

Thread cable through cable access eyelet as shown.

 

 

 

Secure the Luminaire Hood to ceiling grid with self tapping screws (provided) by screwing through the hood and into the bulb of the grid at 80mm centres

Fold corner tab tightly over grid section and secure.

The hood is now installed

 

Replace the surrounding tiles and finish installation of luminaire as recommended by the luminaire manufacturer.

LEGAL:
As part of our policy of ongoing improvements, we reserve the right to modify, alter or change product specifications without giving notice. Product illustrations are representations only. All information contained in this document is provided for guidance only, and as Intuchem Ltd has no control over the installation methods of the products, or of the prevailing site conditions, no warranties expressed or implied are intended to be given as to the actual performance of the products mentioned or referred to, and no liability whatsoever will be accepted for any loss, damage or injury arising from the use of the information given of products mentioned or referred to herein.

The above information to the best of our knowledge is true and accurate and based upon current test data and is supplied for your guidance only. Customers should satisfy themselves to the suitability of the product in its intended use and no guarantee is given or implied since the conditions of actual use are beyond our control. Intuchem Ltd disclaim any liability for loss, damage or other expense arising from the use of information, data or products mentioned or referred to and reserve the right to change any details or specifications without notice.